![Free for ios instal FanControl v160](https://cdn1.cdnme.se/5447227/9-3/screenshot_8_64e62948e087c31b4a9aa5ed.jpg)
![for mac instal Flats for mac instal Flats](https://res.allmacwallpaper.com/get/MacBook-Pro-12-inch-4K-Retina-wallpapers/Salt-Flats-Death-Valley-2304x1440/14868-14.jpg)
This make sense and is a step in the right direction.
![for mac instal Flats for mac instal Flats](https://i.ytimg.com/vi/Ic4v5z-RtzM/maxresdefault.jpg)
I am not a programmer but looking at the code I see that the first part is nothing different to what various Unix bootloader do for allow the Mac to load a non-Apple OS, simply adding MacRISC3 and MacRISC4 to the MacRISC Compatibility string.
![for mac instal Flats for mac instal Flats](https://renewon797.weebly.com/uploads/1/2/6/0/126065383/312570849.jpg)
I have done the modification using two different ROMs:ġ0.2.1 from Classic installation included in OSX 10.4 Install Disc Setīoth ROMs comes from original discs I have, I am sure they are 100% Apple genuine, unmodified before. However I have carefully performed the edit suggested, everytime unmounting the target volume before to reboot the MacMini but so far I have not luck in booting OS9 on that machine. I do not like the way the Hexfiend screenshot are shown on 68KMLA because the ASCII part is too much simplified, it does not show for example the differences beween x00 and x20 that are rendererd both as a blank space, while of course they aren't. The hex editor I used is He圎dit, I prefer it against HexFiend, in this case the byte lenght of edited file is shown in hexadecimal value instead of decimal. Then I have copied the files from OS9General.dmg image of my MDD's restore disk to the first partition of MacMini (all done through firewire connection) and proceed to modify the ROM file in System Folder. Using Disk Utility under 10.4.11 on MDD I have partitioned the MacMini HD in three parts paying attention to install the OS9 drivers too. I have formatted the internal HD connecting the machine via firewire to my MDD and here I have discovered that "target mode" works only between onboard FW port while PCI firewire cards are not supported and if used for this purpose they tend to stop the machine from boot. Currently I am doing this experiment on a MacMini 1.25 Ghz following the 68KMLA thread but until now it didn't work, the OS9 partition is still not bootable.
![Free for ios instal FanControl v160](https://cdn1.cdnme.se/5447227/9-3/screenshot_8_64e62948e087c31b4a9aa5ed.jpg)